Manual
CLEANING THE INLINE
REGULATOR
Disconnect the macroline hosing from your inline regulator
allowing it to be unscrewed from the front regulator mount
(FRM)
SEE FIGURE 10.1.
Turn the inline regulator upside down and carefully
unscrew the two sections SEE FIGURE 10.2. These can be
unscrewed by hand or using a 3/8 hex key in the top and a
5/16 hex key in the bottom of the inline regulator.
By rmly gripping the exposed end of the inline regulator
piston, carefully remove the piston and spring in its
entirety SEE FIGURE 10.3.
Insert a 1/8” hex key into the adjuster screw in the bottom
half of the inline regulator, and wind the screw clockwise
through the bottom section of the regulator body SEE
FIGURE 10.4
and pull free when it will no longer turn
upwards anymore.
Using a dry cotton bud, clean the 011 NBR 70 o-ring that
sits inside the top of the bottom section of the inline
regulator SEE OVERLEAF FIGURE 10.5. Using Eclipse Gun
Oil and a fresh cotton bud, re-lubricate the seal ready for
re-assembly.
WARNING: DEGAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE THE
BARREL, LOADER, AIR SYSTEM AND ANY PAINTBALLS
TO MAKE THE MARKER EASIER AND SAFER TO WORK
ON.
WARNING
NOTE: THE ADJUSTER SCREW CAN ONLY BE REMOVED BY
TURNING IT UPWARDS THROUGH THE BOTTOM SECTION
OF THE INLINE REGULATOR. THE REGULATOR WILL
BECOME DAMAGED IF THE ADJUSTER SCREW IS REMOVED
INCORRECTLY.
NOTE: THE INTERNALS OF YOUR INLINE REGULATOR MAY
VARY ACCORDING TO THE MODEL OF EGO10 THAT YOU
HAVE.
FIG 10.2
FIG 10.3
FIG 10.1
FIG 10.4
50.
MAINTENANCE