Manual

THE SOUND INDICATOR
The sound indicator on the run screen is used to convey if
the SOUND parameter in the HARDWARE menu (page 43) is
switched on or o.
There are two possible conditions that can be indicated:
In order for the trigger to be successfully operated it must
rst be released and then pulled. The trigger detection
indicator (TDI) is used to indicate each of the possible
trigger states.
From the factory the Ego10 will have the Opto sensor
enabled. The micro-switch option can be selected by
referring to the
HARDWARE menu (see page 43).
THE TRIGGER DETECTION
INDICATOR TDI
SOUND ENABLED
The SOUND parameter is enabled. The Ego10
will make sounds when switched on and o
and when the game timer alarms or times out.
SOUND DISABLED
The SOUND parameter is disabled. The Ego10
will not make any sounds.
MICROSWITCH SELECTED, NOT
ACTUATED
The Ego10 is congured to use the micro-
switch to detect trigger pulls. The micro-switch
is not currently actuated, i.e. the trigger is
released.
MICROSWITCH SELECTED, ACTUATED
The Ego10 is congured to use the micro-
switch to detect trigger pulls. The micro-switch
is currently actuated, i.e. the trigger is pulled.
OPTO SENSOR SELECTED, READING
ABOVE PULL POINT
The Ego10 is congured to use the Opto
sensor to detect trigger pulls. The Opto sensor
is currently reading above the Opto pull point,
i.e. the trigger is considered ‘pulled’.
OPTO SENSOR SELECTED, READING 0%
The Ego10 is congured to use the Opto
sensor to detect trigger pulls. The Opto sensor
is currently reading 0%, i.e. the trigger is fully
released.
OPTO SENSOR SELECTED, READING
100%
The Ego10 is congured to use the Opto
sensor to detect trigger pulls. The Opto sensor
is currently reading 100%, i.e. the trigger is
fully depressed.
OPTO SENSOR SELECTED, READING
BELOW RELEASE POINT
The Ego10 is congured to use the Opto
sensor to detect trigger pulls. The Opto sensor
is currently reading below the Opto release
point, i.e. the trigger is considered ‘released’.
OPTO SENSOR SELECTED, READING
MIDRANGE
The Ego10 is congured to use the Opto
sensor to detect trigger pulls. The Opto sensor
is currently reading somewhere between the
Opto release point and the Opto pull point, i.e.
the trigger is half depressed.
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR EGO10
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
INDEX
27.
USING YOUR EGO10
USING YOUR EGO10
QUICK GUIDE