Manual

ECLIPSE SHAFT 3 BARREL
NOTE: THE EGO9 WILL ONLY ACCEPT COCKER THREADED
BARRELS. DO NOT USE ANY OTHER TYPE OF BARREL THREAD.
A
B
D
C
E
NOTE: THE BORE SIZE OF YOUR SHAFT 3 MAY VARY
ACCORDING TO THE MODEL OF EGO9 YOU HAVE.
KNOW YOUR EGO9
RAMMER CAP
RAMMER
BOLT PIN
BODY
CLAMPING LEVER
FEEDNECK
VALVE
PLUG
FRM SCREW
TORPEDO
INLINE REGULATOR ASSEMBLY
FRAME
SCREW
FRAME
SCREW
OOPS
BODY
OOPS
KNOB
BATTERY
VALVE
GUIDE
EXHAUST
VALVE
LPR BODY
LPR CAP
VALVE
SPRING
F
TRIGGER
E
CIRCUIT BOARD
D
PILOT VALVE
C
SOLENOID ASSEMBLY
B
EYE COVER
A
EYE COVER SCREW
F
E
C
D
A
B
MACRO LINE
ELBOW
OOPS
INSERT
OOPS PIN
BOLT
OOPS
SCREWS
Your Eclipse Ego9 comes as standard with an Eclipse Shaft 3 barrel.
The barrel screws into the body of the Ego9 using a right hand thread
meaning that if you hold the Ego9 pointing away from you the barrel screws
into the body in a counter-clockwise direction.
The barrel comprises of two parts, a barrel back and a barrel front .
The two parts are joined together with a left hand thread meaning that
if you hold the barrel, with the back nearest you, the front unscrews in a
counter-clockwise direction. The bore size of the barrel back is engraved at
the end of the barrel back .
On the barrel back there is a 016 NBR 70 o-ring which prevents the barrel
from vibrating loose from the Ego9 body when the marker is fired. There is
also a 015 NBR 70 o-ring on the barrel front helps with alignment when
the two sections are screwed together.
Replace and lubricate these o-rings with Eclipse Grease as necessary.
E
D
C
A
B
6.
ORIENTATION
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR EGO9
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
7.
ORIENTATION
ORIENTATION
QUICK GUIDE