Manual

THE EGO9 TRIGGER
ASSEMBLY
Having removed the trigger frame completely from the
Ego9 body (see page 63), use a 5/64 hex key to remove
the two screws that hold the bearing carrier in place
in the top of the frame (SEE FIGURE 15.1). Gently lift
the bearing carrier and trigger assembly free from the
trigger frame taking care not to damage the micro-
switch or the Opto sensors (SEE FIGURE 15.2).
Using a 1/16” hex key, loosen the trigger pin retaining
set screw from the bottom of the trigger (SEE FIGURE
15.3). Use a small hex key to push the trigger pin out of
the bearing carrier from one side (SEE FIGURE 15.4).
Clean the trigger and bearing carrier thoroughly and
also clean the space within the frame that the trigger
sits into.
Carefully remove the Trigger Spring from the spring
hole in the top of the trigger and clean off any paint
debris or moisture from it (SEE FIGURE 15.5).
WARNING: DE-GAS YOUR MARKER, DISCHARGING
ANY STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER AND AIR SYSTEM TO MAKE THE
MARKER EASIER TO WORK ON.
WARNING
ATTACHING THE FRAME
WARNING: DE-GAS YOUR MARKER, DISCHARGING
ANY STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER AND AIR SYSTEM TO MAKE THE
MARKER EASIER TO WORK ON.
WARNING
Carefully thread the solenoid and break beam sensor
system wires through the access holes in the top of the
Ego9 grip frame (SEE FIGURE 14.5) and re-attach the
grip frame to the marker body by tightening the two
grip frame screws using a 1/8” hex key (SEE FIGURE 14.6).
Ensure that the break beam sensor system cables
lie neatly in the slots provided for them in the Ego9
grip frame and connect the solenoid and the break
beam sensors to their relevant connections on the
Ego9 circuit board (SEE FIGURE 14.7). Adjust both the
solenoid wires and the break beam sensor system wires
so that they sit neatly within the grip frame
(SEE FIGURE 14.8).
Re-attach the Ego9 rubber grips to the frame by using a
5/64” hex key to replace the 6 grip screws.
FIG 15.2
FIG 15.3
FIG 15.1
FIG 15.4
FIG 14.6
FIG 14.7
FIG 14.8
FIG 14.5
FIG 15.5
64.
MAINTENANCE
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR EGO9
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
65.
MAINTENANCE
MAINTENANCE
QUICK GUIDE