Manual

REMOVING THE FRAME
Disconnect any hosing and unscrew the Inline
Regulator from the front regulator mount as detailed
in the “Cleaning the Inline Regulator section of this
Maintenance guide (pages 56-57).
Using a 5/64” hex key remove the six screws that
attach the Ego9 rubber grips to the Ego9 grip frame
(SEE FIGURE 14.1). Unplug the solenoid and unplug the
break beam sensor system from their connections on
the Ego9 circuit board (SEE FIGURE 14.2).
Using a 1/8” hex key undo the two frame retaining
screws (SEE FIGURE 14.3) and remove the frame from
the Ego9 body, taking care not to damage any wires
(SEE FIGURE 14.4).
You have now removed the frame.
WARNING: DE-GAS YOUR MARKER, DISCHARGING
ANY STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER AND AIR SYSTEM TO MAKE THE
MARKER EASIER TO WORK ON.
WARNING
CLEANING AND
LUBRICATING THE BOLT
Raise the Bolt pin and remove the Bolt and Bolt pin
from the Ego9 marker body (FIGURE 13.1).
Using a dry cotton bud remove any paint or grease
from the surface of the Bolt (SEE FIGURE 13.2).
Lubricate the Bolt (SEE FIGURE 13.3) and replace the
Bolt, locking the Bolt pin into the designated slot in the
Rammer (SEE FIGURE 13.4).
WARNING: THIS PROCEDURE CAN BE PERFORMED
WITH THE EGO9 GASSED UP AS WELL AS DE-GASSED. IF
PERFORMING THIS PROCEDURE WITH THE EGO9 GASSED
UP ENSURE A BARREL BLOCKING DEVICE IS USED AND
THAT THE EGO9 IS SWITCHED OFF TO MAKE THE SYSTEM
SAFER TO WORK ON.
WARNING
FIG 13.7
FIG 14.3
NOTE: WE RECOMMEND THE USE OF ECLIPSE GUN OIL ON
THE EGO9 RAMMER AND BOLT.
FIG 13.2
FIG 13.1
FIG 13.3
FIG 14.4
DOT
FIG 13.4
FIG 14.2
FIG 14.1
62.
MAINTENANCE
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR EGO9
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
63.
MAINTENANCE
MAINTENANCE
QUICK GUIDE