Manual

MAINTAINING THE
RAMMER
Pull the Bolt pin upwards so that it disengages the
Rammer, allowing the bolt to be removed via the rear
of the Ego9 (SEE FIGURE 12.1).
Using a 3/16" hex key, unscrew and remove the
Rammer Cap at the rear of the Ego9 (SEE FIGURE 12.2).
Raise the front of the Ego9 and tap the Ego9 onto your
hand until the rammer falls into the palm of your hand
(SEE FIGURE 12.3).
Thoroughly clean the Rammer Shaft and all of its seals,
paying special attention to the 009 NBR 70 o-ring on
the middle of the Shaft (SEE FIGURE 12.4), the rear 011
NBR 70 o-ring (SEE FIGURE 12.5) and the condition
of the bumper in the Rammer Cap (SEE FIGURE 12.6
OVERLEAF).
Replace any worn seals/bumpers using authentic
Eclipse Ego9 spare parts.
WARNING: DE-GAS YOUR MARKER, DISCHARGING
ANY STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER AND AIR SYSTEM TO MAKE THE
MARKER EASIER TO WORK ON.
WARNING
(CONTINUED)
Lubricate all of the seals on the Rammer Shaft and
inside the Rammer Cap and replace the Rammer into
the rear of the Ego9 body as shown in (SEE FIGURE 12.7).
Replace the Rammer Cap, using the 3/16" hex key to
secure it into the Ego9 body (SEE FIGURE 12.8).
Noting the position of the Rammer in the Ego9 body
(SEE FIGURE 12.9), replace the Bolt and locate the Bolt
pin into the designated groove in the Rammer Shaft
(SEE FIGURE 12.10).
FIG 12.3
FIG 12.5FIG 12.4
FIG 12.1
FIG 12.7
FIG 12.8
FIG 12.10FIG 12.9
FIG 12.6
DOT
NOTE: DO NOT USE ECLIPSE GREASE ON THE RAMMER. ONLY
USE LIGHT PAINTGUN OIL, WE RECOMMEND ECLIPSE GUN
OIL.
NOTE: THE NUMBER OF O-RINGS ON THE RAMMER MAY
VARY ACCORDING TO THE MODEL OF EGO9 THAT YOU HAVE.
NOTE: DO NOT OVER TIGHTEN THE RAMMER CAP SCREW.
FIG 12.2
60.
MAINTENANCE
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR EGO9
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
61.
MAINTENANCE
MAINTENANCE
QUICK GUIDE