Manual

(CONTINUED)
I nsert the front spring (silver in colour) into the LPR Cap,
so that it rests neatly on the adjuster screw (SEE FIGURE
11.5).
Place the gold coloured spring onto the LPR Piston and
insert Piston and Spring into the LPR Cap, o-ring end
first (SEE FIGURE 11.6).
Before screwing the LPR Cap back onto your Ego9, use
a dry cotton bud to clean the 010 NBR 70 o-ring inside
the LPR Body (SEE FIGURE 11.7). Lubricate this seal using
a light 3 in 1 oil, such as Eclipse Gun Oil.
Replace the LPR cap by screwing it onto the LPR Body
in the Ego9 (SEE FIGURE 11.8).
CLEANING THE LOW
PRESSURE REGULATOR
(LPR)
Note: The internals of your LPR may vary according to
the model of Ego9 that you have.
The Inline Regulator can be removed if needs be.
Unscrew the LPR Cap from the marker body
(SEE FIGURE 11.1).
Remove the LPR Piston and rear spring from the LPR
Cap (SEE FIGURE 11.2).
Cupping the palm of one hand, turn the LPR Cap upside
down and tip the front spring out into your palm (SEE
FIGURE 11.3).
Remove the rear spring from the LPR Piston and
using a dry cotton bud, carefully clean the 013 NBR 70
o-ring on the LPR Piston (SEE FIGURE 11.4). If the seal
is damaged then replace it. Once the seal has been
cleaned, lubricate with a light application of Eclipse
Grease so that it is ready for re-assembly.
WARNING: DE-GAS YOUR MARKER, DISCHARGING
ANY STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER AND AIR SYSTEM TO MAKE THE
MARKER EASIER TO WORK ON.
WARNING
FIG 11.6 FIG 11.7
FIG 11.8
FIG 11.5
NOTE: THE ADJUSTER SCREW DOES NOT NEED TO BE
REMOVED FROM THE LPR CAP FOR REGULAR MAINTENANCE.
FIG 11.2
FIG 11.4
FIG 11.3
FIG 11.1
58.
MAINTENANCE
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR EGO9
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
59.
MAINTENANCE
MAINTENANCE
QUICK GUIDE