Manual
> MS xx:
Load a set of parameters
that configures the Ego9 to comply
with the 20xx Millennium Series rules
governing firing modes.
> CANCEL:
Editing is cancelled and the
parameter remains unchanged.
> USER 1:
Load a set of custom firing
mode parameters that have been
previously saved by the user.
> USER 2:
Load a second set of custom
firing mode parameters that have
been previously saved by the user.
With the exception of
FACTORY each
of the Presets changes only those
parameters that control the firing
mode of the Ego9, leaving FILTER,
TIMING and HARDWARE parameters
unchanged.
SAVE
THE SAVE PRESET PARAMETER
This parameter is used to save the
current set of parameters as a user
defined custom Preset configuration.
This parameter has the following
choices:-
> USER 1:
Save the current parameters
as the Preset ‘USER 1’.
> USER 2:
Save the current parameters
as the Preset ‘USER 2’.
> CANCEL:
Editing is cancelled and the
parameter remains unchanged.
MODE
THE FIRING MODE PARAMETER
This parameter is used to select the firing mode of the
Ego9 and has the following choices:
> SEMI:
This is the default and in this firing mode the
Ego9 will fire one shot for every trigger pull.
> RAMP:
In this firing mode, the rate of fire is increased
above the rate at which the trigger is pulled once
certain criteria have been met. These criteria are set by
the parameters on the Ramp Set Menu.
> CANCEL:
Editing is cancelled and the parameter is
unchanged.
PLEASE NOTE: CERTAIN MODES MAY ONLY BE AVAILABLE
IN CERTAIN COUNTRIES AND ON CERTAIN MODELS OF THE
EGO9.
ROF CAP
THE RATE OF FIRE CAP PARAMETER
The
ROF CAP parameter is used to specify whether or
not the Ego9 should have a limited, or capped rate
of fire. When the ROF CAP is enabled, the maximum
achievable rate of fire is set by the MAX ROF parameter.
Choices for the ROF CAP parameter are:-
> OFF:
Rate of fire only limited by the loader.
> ON:
Rate of fire limited to the MAX ROF parameter
value.
> CANCEL:
Cancel editing and leave the parameter
unchanged.
MAX ROF
THE MAXIMUM RATE OF FIRE PARAMETER
The
MAX ROF parameter is used to set the maximum
achievable rate of fire from the Ego9. The value of this
parameter can be adjusted between 10.0 and 30.0 balls
per second in 0.1bps increments.
The
MAX ROF parameter will only be displayed if you
have set the ROF CAP parameter to ‘ON’.
NOTE: THE CURRENT PRESET CONFIGURATION CAN BE VIEWED
FROM THE RUN SCREEN BY PRESSING THE BUTTON.
38.
ADVANCED SET-UP
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR EGO9
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
39.
ADVANCED SET-UP
ADVANCED SET-UP
QUICK GUIDE