User's Manual

SYMPTOM POSSIBLE
CAUSE
The marker is chopping or trapping paint.
The Ego8 fires yet bolt doesn’t move.
QEV Block leaks.
The Ego8 does not fire.
Low Velocity First Shot.
High Velocity First Shot.
The Break-Beam Sensor System is switched off.
The Bolt is dirty, causing the sensor system to
incorrectly detect a paintball.
The Break-Beam Sensor System is dirty causing
the incorrect detection of paintballs.
Bolt pin is not located in Rammer correctly.
Main Rammer seal is damaged.
Faulty seals inside QEV Block.
Trigger is set up incorrectly.
Solenoid is not plugged into the Ego8 PCB.
The Break-Beam Sensor System is enabled but
there is no paint.
Microswitch is not being activated.
Microswitch is damaged.
FSDO parameter is too low to overcome stiction
on Solenoid and / or Rammer O-rings.
FSDO parameter set too high.
Inline Regulator pressure creeping.
Switch on the Break-Beam Sensor System.
Clean the Bolt.
Clean the Break-Beam Sensor System.
Lift Bolt pin and line up with position of rammer
correctly (See Maintenance Section).
Replace 011 seal on Rammer Shaft.
Strip QEV Block and inspect seals for debris or
damage.
Set trigger up correctly.
(See Advanced Set-Up Section)
Plug solenoid into port on the Ego8 PCB.
Fill loader with paint.
Adjust Microswitch activation screw accordingly.
Replace circuit board.
Increase FSDO parameter.
Reduce FSDO parameter.
Strip and clean Inline Regulator. Replace Inline
Regulator piston if necessary.
SOLUTION
68.
FAULT FINDING