User's Manual

RETAINER
CLIP
FRONT
QEV
CAP
QEV
DIAPHRAGM
FRONT QEV
INSERT
RETAINER
CLIP
BARB
QEV BLOCK
QEV DIAPHRAGM
REAR QEV CAP
(CONTINUED)
Repeat the above process on the Front end of the QEV Block
assembly using a pick to push up the Front QEV Block Retainer
Clip (SEE FIGURE 17.7) and then to lift the Front QEV Block
Retainer Clip free from the QEV Block (SEE FIGURE 17.8). The
contents of the QEV Block should now look like FIGURE 17.9.
To correctly assemble the QEV Block it is essential that the
internal components are arranged in the correct order. Using a
cotton bud soaked in Eclipse Oil, lubricate the chambers at both
the back and front of the QEV Block. Referring to FIGURE 17.10,
assemble the QEV Block as shown, ensuring that once the Front
and Rear QEV Caps hold the relevant internals in place they are
secured by the Retainer Clips.
It is Important to pay attention to the orientation of the QEV
Diaphragm and to make sure that they are sat in the correct
position before inserting the end caps. Make sure they are
perfectly square and not tilted over.
You have now successfully stripped and cleaned your QEV Block.
FIG 17.7
FIG 17.8
FIG 17.9
FIG 17.10
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR EGO8
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
65.
MAINTENANCE
MAINTENANCE
QUICK GUIDE