User's Manual

HOW TO ASSEMBLE

THE EGO8

Lubricate both of the o-rings on the exhaust valve guide with

Eclipse Oil (SEE FIGURE 14.1). Place the exhaust valve in the

exhaust valve guide, making sure that the sealing faces are

next to each other, and place the valve spring over the end of

the exhaust valve (SEE FIGURE 14.2). Holding the exhaust valve

guide so that the closed side of it is facing the bottom of the

marker body, insert the exhaust valve guide, exhaust valve and

valve spring into the front of the marker body (SEE FIGURE 14.3).

When the exhaust valve is in the correct place, you will be able

to see the closed side through the valve plug hole in the Ego8

body (SEE FIGURE 14.4). Make sure that the exhaust valve guide

is lined up correctly and then take a 1/8” hex key and replace the

valve plug (SEE FIGURE 14.5).

Lubricate the o-rings on the LPR body with Eclipse Oil (SEE

FIGURE 14.6)

and slide the LPR assembly into the front of the

Ego8 marker body until the hole in the LPR body lines up with

the hole in the front regulator mount (SEE FIGURE 14.7).

WARNING: DE-GAS YOUR MARKER, DISCHARGING ANY STORED GAS

IN A SAFE DIRECTION, AND REMOVE THE BARREL, LOADER AND AIR

SYSTEM TO MAKE THE MARKER EASIER TO WORK ON.

WARNING

FIG 14.2 FIG 14.3

FIG 14.4 FIG 14.5

FIG 14.6 FIG 14.7

FIG 14.1

NOTE: DO NOT OVER TIGHTEN THE VALVE PLUG.!

CONTENTS

ORIENTATION

QUICK SET-UP

USING YOUR EGO8

ADVANCED SET-UP

MENU TREE

MAINTENANCE

FAULT FINDING

SERVICE CENTERS

PARTS LIST

SPARES & ACCESSORIES

59.

MAINTENANCE

QUICK GUIDE