User's Manual

UNDERSTANDING
THE BBSS INDICATOR
(BBSS)
The BBSS is able to switch itself off in the event that a blockage
or contamination prevents it from functioning correctly. In this
instance, the BBSS will switch itself back on once the blockage is
cleared and the correct operation can be resumed.
The BBSS Indicator on the main screen is used to indicate the
eight possible states of the BBSS as follows:
BBSS ENABLED AND BALL
DETECTED
The Ego8 can be fired at the maximum rate of fire
determined by the chosen firing mode.
BBSS SENSOR FAULT HAS
BEEN CLEARED
The sensor has been re-enabled. A ball is detected
and the Ego8 can be fired at the maximum rate of
fire determined by the chosen firing mode.
BBSS ENABLED NO BALL
DETECTED
The Ego8 cannot be fired.
BBSS FAULT HAS BEEN
CLEARED
The sensor is enabled. No ball is detected so the
Ego8 cannot be fired. To reset the BBSS icon, use
the button to switch off the BBSS and then
back on again.
BBSS DISABLED
The Ego8 can be fired at a maximum rate of fire as
set by the OFF ROF parameter (SEE PAGE 36)
BBSS ENABLED IN
TRAINING MODE
The BBSS has been over-ridden as the user has
selected training mode. As the user has chosen
to leave the BBSS on, the achievable rate of fire is
limited by the firing mode.
BBSS FAULT DETECTED
The system is disabled. The Ego8 can only be fired
at a maximum rate of fire of 10bps, regardless of
the chosen firing mode.
BBSS DISABLED IN
TRAINING MODE
The BBSS has been over-ridden as the user has
selected training mode. As the user has chosen
to turn the BBSS off, the achievable rate of fire is
limited by the OFF ROF parameter (see page 36).
20.
USING YOUR EGO8