User's Manual

ADJUSTING
THE VELOCITY
When using your Ego8, you may wish to change the velocity
at which your Ego8 is firing. This is done by inserting a 1/8" hex
key into the adjuster screw at the bottom of your Ego8 Inline
Regulator and adjusting it accordingly (SEE FIGURE 6.1). By
turning this adjuster screw clockwise you decrease the output
pressure of the Inline Regulator and consequently the velocity,
by turning the adjuster screw counter clockwise you increase
the output pressure of the Inline Regulator and consequently
the velocity.
ADJUSTING THE LPR
PRESSURE
When using your Ego8, you may wish to change the output
pressure of your LPR. This is easily done by inserting a 5/32"
inch hex key into the adjuster screw at the front and adjusting it
accordingly (SEE FIGURE 6.2). However we recommend that the
LPR screw be left set flush with the front of the LPR cap.
By turning the adjuster screw clockwise, you decrease the output
pressure of your LPR and consequently reduce the pressure
driving your rammer back and forth. By turning the adjuster
screw counter clockwise, you increase the output pressure of
your LPR and consequently increase the pressure driving your
rammer back and forth.
NOTE: AFTER EACH ADJUSTMENT FIRE TWO CLEARING SHOTS TO
GAIN AN ACCURATE VELOCITY READING. NEVER EXCEED 300FPS.
NOTE: TURNING THE ADJUSTER SCREW OUT TOO FAR WILL CAUSE
IT TO FALL OUT.
FIG 6.1
FIG 6.2
18.
USING YOUR EGO8