User's Manual

SETTING

THE TRIGGER CONT...

The Magnet Return Strength Screw is used to adjust the amount

of force with which the trigger is returned to its rest position by

the magnet. Turn the screw clockwise to increase the amount of

force. Do not turn the screw too far or it will negate the position

of the Front Stop Trigger Screw. Turn the screw counter clockwise

to reduce the amount of force. Do not turn the screw too far or

there will not be enough force to return the trigger (SEE FIGURE

7.3).

The Micro Switch Activation Screw is used to adjust the point in

the trigger pull at which the micro-switch is activated. Turn the

screw clockwise to decrease the amount of trigger travel to the

activation point. Turn the screw counter clockwise to increase

the amount of trigger travel to the activation point (SEE FIGURE

7.4).

If you have selected SWITCH from the HARDWARE Menu and are

consequently using the micro-switch as the method of trigger

detection then check that the micro-switch activates and de-

activates fully on each trigger pull and trigger release. If you have

selected OPTO from the HARDWARE Menu and are using the

OPTO sensor as the method of trigger detection, refer to setting

the BAND HI and BAND LO (SEE PAGE 45-46) as it is crucial that the

trigger pull and trigger ﬁlters are set up together for the trigger

ﬁltering to work correctly.

FIG 7.3

FIG 7.4

CONTENTS

ORIENTATION

QUICK SET-UP

USING YOUR EGO8

ADVANCED SET-UP

MENU TREE

MAINTENANCE

FAULT FINDING

SERVICE CENTERS

PARTS LIST

SPARES & ACCESSORIES

17.

USING YOUR EGO8

QUICK GUIDE