User's Manual

INSTALLING AN
ADJUSTABLE
AIR SYSTEM
Firstly disconnect the macroline hosing from the elbow attached
to the OOPS at the base of the grip frame
(SEE FIGURE 4.4).
Unscrew the On/Off knob completely from the OOPS and
using a 3/32” hex key turn the two screws on the bottom of the
OOPS in a counter clockwise direction so that the OOPS can be
removed from the rail by sliding it backwards (SEE FIGURE 4.5).
As well as the integrated slide rail at the base of the Ego8’s grip
frame, there are also two 10-32 UNF threaded screw holes which
will accept all standard bottom line screws (SEE FIGURE 4.6).
Attach the air system of your choice, taking care to ensure that
you use the correct length and size of hosing to accommodate
your requirements.
BEFORE ATTACHING ANY FIXED AIR SYSTEM, PLACE ATTACHING SCREW
IN DESIGNATED SLIDE RAIL AND MEASURE PROTRUDING SCREW LENGTH.
SCREW LENGTH MUST NOT PROTRUDE MORE THAN 10MM/0.40”
OTHERWISE THE EGO8 CIRCUIT BOARD WILL BECOME DAMAGED.
WARNING
FIG 4.6
FIG 4.5
FIG 4.4
14.
USING YOUR EGO8