Manual

(CONTINUED)
Positioning the trigger so that the hole through the trigger lines
up with the holes in the bearing carrier, slide the trigger pin in
place and using a 1/16” hex key tighten down the trigger pin
retaining set screw to hold the assembly together (SEE FIGURE
15.5).
Gently lower the trigger assembly and bearing carrier into the
frame, taking care not to damage the micro-switch or the opto
sensor, and ensuring that the trigger is positioned correctly (SEE
FIGURE 15.6)
. Using a 5/32 hex key tighten the two screws that
hold the bearing carrier in place in the top of the Ego8 frame.
You have now stripped and cleaned your Ego8 trigger.
FIG 15.5
FIG 15.6
62.
MAINTENANCE