Manual
CLEANING THE
TRIGGER ASSEMBLY
Having removed the trigger frame completely from the Ego8
body, use a 5/32” hex key to remove the two screws that hold the
bearing carrier in place in the top of the frame (SEE FIGURE 15.1).
Gently lift the bearing carrier and trigger assembly free from the
trigger frame taking care not to damage the micro-switch or the
opto sensors (SEE FIGURE 15.2).
Using a 1/16” hex key, loosen the trigger pin retaining set screw
from the rear of the trigger (SEE FIGURE 15.3). Use a small hex
key to push the trigger pin out of the bearing carrier from one
side (SEE FIGURE 15.4) Clean the trigger and bearing carrier
thoroughly and also clean the space within the frame that the
trigger sits into.
FIG 15.2 FIG 15.3
FIG 15.1
FIG 15.4
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR EGO8
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
61.
MAINTENANCE
MAINTENANCE
QUICK GUIDE