Manual

(CONTINUED)
Using a 1/8” hex key replace the screw that secures the LPR body
into the marker body (SEE FIGURE 14.8).
Carefully thread the solenoid and break beam sensor system
wires through the access holes in the top of the Ego8 grip frame
(SEE FIGURE 14.9) and re-attach the grip frame to the marker
body by tightening the two grip frame screws using a 1/8 hex
key (SEE FIGURE 14.10).
Ensure that the break beam sensor system cables lie neatly in
the slots provided for them in the Ego8 grip frame and connect
the solenoid and the break beam sensors to their relevant
connections on the Ego8 circuit board (SEE FIGURE 14.11).
Adjust both the solenoid wires and the break beam sensor
system wires so that they sit neatly within the grip frame
(SEE FIGURE 14.12).
Re-attach the Ego8 rubber grips to the frame by using a 5/64”
hex key to replace the 6 grip screws. Screw the inline regulator
back into the front regulator mount (SEE FIGURE 14.13) and
connect any hosing that was disconnected earlier (SEE FIGURE
14.14). Lift the bolt pin and slide the bolt into position, locating
the bolt pin in the designated groove in the rammer.
You have now assembled your Ego8.
FIG 14.9 FIG 14.10
FIG 14.11 FIG 14.12
FIG 14.13 FIG 14.14
FIG 14.8
NOTE: CHECK THAT NO WIRES ARE TRAPPED BEFORE TIGHTENING
DOWN THE FRAME SCREWS
NOTE: TWIST THE BBSS WIRES SO THAT THEY DO NOT OBSTRUCT
THE MOVEMENT OF THE MICRO-SWITCH LEVER.
60.
MAINTENANCE