Manual

(CONTINUED)
Remove the entire LPR assembly, the valve spring and the
exhaust valve from the marker body (SEE FIGURE 13.7). Using a
1/8” hex key remove the valve plug from the underside of the
Ego8 body (SEE FIGURE 13.8). The bottom of the exhaust valve
guide should now be visible through the valve plug hole (SEE
FIGURE 13.9)
. Ensure that the rammer is in its rear position and
taking an L-shaped hex key, place it down through the bolt
slot in the top of the body so that you can apply light pressure
to pop the valve guide out of its place in the Ego8 body (SEE
FIGURE 13.10).
Note how one side of the exhaust valve guide is flat
(SEE FIGURE 13.11), whilst the other is raised to create the surface
that the exhaust valve seals on (SEE FIGURE 13.12). Inspect the
sealing face of both the exhaust valve guide and the exhaust
valve for any excessive wear or damage. If the exhaust valve or
the exhaust valve guide is damaged then replace with authentic
Ego8 parts.
You have now stripped the Ego8.
FIG 13.9 FIG 13.10
FIG 13.8FIG 13.7
FIG 13.11 FIG 13.12
58.
MAINTENANCE