Manual
(CONTINUED)
Lubricate all of the seals on the rammer shaft and inside the
rammer cap and replace the rammer into the rear of the Ego8
body as shown in (SEE FIGURE 12.7).
DO NOT use grease or vaseline on the rammer. Only use light
paintgun oil, we recommend Eclipse Oil.
Replace the rammer cap, using the 3/16" hex key to secure it into
the Ego8 body (SEE FIGURE 12.8).
DO NOT over tighten the rammer cap screw.
Noting the position of the rammer in the Ego8 body (SEE FIGURE
12.9), replace the bolt and locate the bolt pin into the designated
groove in the rammer shaft (SEE FIGURE 12.10).
FIG 12.7 FIG 12.8
FIG 12.10FIG 12.9
FIG 12.6
DOT
56.
MAINTENANCE