Manual
CLEANING AND
LUBRICATING THE
RAMMER
Note: The number of o-rings on the rammer may vary according to
the model of Ego8 that you have.
Pull the bolt pin upwards so that it disengages the rammer,
allowing the bolt to be removed via the rear of the Ego8 (SEE
FIGURE 12.1).
Using a 3/16" hex key, unscrew and remove the rammer cap at
the rear of the Ego8 (SEE FIGURE 12.2).
Raise the front of the Ego8 and tap the Ego8 onto your hand
until the rammer falls into the palm of your hand (SEE FIGURE
12.3).
Thoroughly clean the rammer shaft and all of its seals, paying
special attention to the seal on the middle of the shaft
(SEE FIGURE 12.4), the rear seal (SEE FIGURE 12.5) and the
condition of the bumper in the rammer cap (SEE FIGURE 12.6
overleaf).
Replace any worn seals/bumpers using authentic Eclipse Ego8
spare parts.
WARNING: DE-GAS YOUR MARKER, DISCHARGING ANY STORED GAS
IN A SAFE DIRECTION, AND REMOVE THE BARREL, LOADER AND AIR
SYSTEM TO MAKE THE MARKER EASIER TO WORK ON.
WARNING
FIG 12.2 FIG 12.3
FIG 12.5FIG 12.4
FIG 12.1
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR EGO8
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
55.
MAINTENANCE
MAINTENANCE
QUICK GUIDE