Manual

(CONTINUED)
Remove the rubber finger detent and using a dry cotton bud
clean the detent and it’s location point in the Ego8 Body. (SEE
FIGURE 9.4)
Replace the detent back into the Ego8 body (SEE
FIGURE 9.5)
and place the BBSS back into the designated slot in
the body (SEE FIGURE 9.2). Ensure that the sensor is face down in
the body i.e looking into the breech.
Replace the Sensor Cover and using a 5/64" hex key, replace the
Bream Beam Sensor Cover retaining screw to hold the sensor
cover in place (SEE FIGURE 9.6).
Be careful not to cross-thread the screw. Do not over tighten the
screw.
Repeat procedure for opposite side of the Ego8.
You have now cleaned your Break-Beam Sensor System.
NOTE: WHEN CLEANING BREAK-BEAM SENSOR SYSTEM INSPECT
CONDITION OF RUBBER FINGER DETENTS AND REPLACE IF
NECESSARY. ENSURE THAT THE RECEIVER SENSOR (INDICATED BY A
RED MARK & RED HEAT SHRINK) IS LOCATED ON THE RIGHT-HAND
SIDE OF THE MARKER BODY.
FIG 9.6
FIG 9.5
FIG 9.4
50.
MAINTENANCE