Manual
ATTACHING A LOADER
Using a 5/32” hex key, turn the top screw of the clamping feed
neck counter clockwise (SEE FIGURE 5.1).
Release the clamping lever on the feed neck (SEE FIGURE 5.2)
and test to see if your loader can easily be pushed into the top
of the feed neck. If the loader cannot easily be pushed into the
feed neck, loosen the top screw of the clamping feed neck a little
more by turning it counter clockwise using a 5/32” hex key (SEE
FIGURE 5.1).
When you have managed to push your loader into the clamping
feed neck, close the clamp to secure it firmly in place (SEE FIGURE
5.3). If the loader is loose then you will need to release the clamp,
tighten the screw slightly by turning it clockwise with a 5/32” hex
key and closing the clamp. Repeat this process as necessary to
secure your loader in place.
You have now attached a loader to your Ego8. Once you have
filled your loader and air tank you will then be ready to begin
using your Ego8.
FIG 5.3
FIG 5.2
FIG 5.1
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR EGO8
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
15.
USING YOUR EGO8
USING YOUR EGO8
QUICK GUIDE