Manual

SETTING UP
Before you can begin to use your Ego8, you will need to attach
an air-system and a paintball loader.
INSTALLING A
PRESET AIR SYSTEM
Every Ego8 comes complete with an Eclipse On/Off Purge
System (OOPS) which provides a direct connection for a preset
air system. Before screwing the air system into the OOPS ensure
that the On/Off knob is wound out approximately half way (SEE
FIGURE 4.1).
Be careful not to unscrew the On/Off knob too far as it will come
completely off the OOPS. If this happens, replace the On/Off
knob by screwing it back onto the OOPS body in a clockwise
direction.
Screw the preset air system into the OOPS (SEE FIGURE 4.2) so
that the bottle screws in all the way and is tight. Slowly turn
the On/Off knob in a clockwise direction allowing the OOPS
to depress the pin of the preset air system causing the Ego8 to
become pressurized, providing that there is sufficient air in your
tank (SEE FIGURE 4.3).
You have now installed a preset air system onto your Ego8.
NOTE: WHEN USING AN OOPS ON YOUR EGO8, THE EGO8 WILL STILL
HAVE STORED AIR IN THE VALVE CHAMBER, GAS LINE AND INLINE
REGULATOR AFTER YOU HAVE SWITCHED THE OOPS OFF. PLEASE
REMEMBER TO DISCHARGE THE STORED AIR IN A SAFE DIRECTION AS
YOU ARE UNSCREWING THE ON/OFF KNOB ON THE OOPS.
NOTE: THE EGO8 CANNOT BE USED WITH CO2, IT CAN ONLY BE
POWERED BY COMPRESSED AIR OR NITROGEN.
FIG 4.3
FIG 4.2
FIG 4.1
12.
USING YOUR EGO8