Manual

USING THE BREAK
BEAM SENSOR
SYSTEM
The Break Beam Sensor System is used to detect when a
paintball is ready to fire from the Ego8. If no paintball is ready
then the BBSS will inhibit the Ego8 from firing. This prevents the
Ego8 from ‘chopping’ paintballs that are not fully loaded into the
marker.
To switch off the Break-Beam Sensor System, press and hold the
button for 0.5 second (SEE FIGURE 3.3).
The break beam sensor system indicator on the top right of the
LCD will change from (enabled) to (disabled) .
To switch the Break-Beam Sensor System back on, press and hold
the button for one second. The indicator will change back to
.
When the Break-Beam Sensor System is enabled, the indicator
will change depending on if the system has detected a ball or
not. When no ball has been detected the indicator looks like
this when a ball has been detected the icon changes to look
like this .
Additional features of the Ego8’s Break-Beam Sensor System are
covered in full on page 20 of this user manual.
NOTE: WHEN THE EGO8 IS TURNED ON, THE BREAK-BEAM SENSOR
SYSTEM IS AUTOMATICALLY ENABLED
FIG 3.3
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR EGO8
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
11.
QUICK SET-UP
QUICK SET-UP
QUICK GUIDE