User's Manual

SYMPTOM POSSIBLE CAUSE
The marker is chopping or trapping paint.
The Ego7 res yet bolt doesn’t move.
QEV leaks.
The Ego7 does not re.
Low Velocity First Shot.
High Velocity First Shot.
The Break-Beam Sensor System is switched off.
The Bolt is dirty, causing the sensor system to
incorrectly detect a paintball.
The Break-Beam Sensor System is dirty causing
the incorrect detection of paintballs.
Bolt pin is not located in Rammer correctly.
Main Rammer seal is damaged.
Faulty seals inside QEV.
Trigger is set up incorrectly.
Solenoid is not plugged into the Eclipse Ego7
PCB.
The Break-Beam Sensor System is enabled but
there is no paint.
Microswitch is not being activated.
Microswitch is damaged.
FSDO parameter is too low to overcome stiction
on Solenoid and / or Rammer O-rings.
FSDO parameter set too high.
Inline Regulator pressure creeping.
Switch on the Break-Beam Sensor System.
Clean the Bolt.
Clean the Break-Beam Sensor System.
Lift Bolt pin and line up with position of rammer
correctly (SEE MAINTENANCE SECTION) .
Replace 011 seal on Rammer Shaft.
Strip QEV and inspect seals for debris or
damage.
Set trigger up correctly.
(SEE ADVANCED SET-UP SECTION)
Plug solenoid into port on the Eclipse Ego7
PCB.
Fill loader with paint.
Adjust Microswitch activation screw accordingly.
Replace circuit board.
Increase FSDO parameter.
Reduce FSDO parameter.
Strip and clean Inline Regulator. Replace Inline
Regulator piston if necessary.
SOLUTION
