User's Manual

(CONTINUED)
Using a 1/8th” hex key replace the screw that secures the
LPR body into the marker body (SEE FIGURE 14.8).
Carefully thread the solenoid and break beam sensor system
wires through the access holes in the top of the Ego7 grip
frame (SEE FIGURE 14.9) and re-attach the grip frame to the marker
body by tightening the two grip frame screws using a 1/8th”
hex key (SEE FIGURE 14.10).
Ensure that the break beam sensor system cables lie neatly
in the slots provided for them in the Ego7 grip frame and
connect the solenoid and the break beam sensors to their
relevant connections on the Ego7 circuit board (SEE FIGURE 14.11).
Adjust both the solenoid wires and the break beam sensor
system wires so that they sit neatly within the grip frame
(SEE FIGURE 14.12).
Re-attach the Ego7 rubber grips to the frame by using a
5/64th” hex key to replace the 6 rubber grip screws. Screw
the inline regulator back into the front regulator mount
(SEE FIGURE 14.13) and connect any hosing that was disconnected
earlier (SEE FIGURE 14.14). Lift the bolt pin and slide the bolt into
position, locating the bolt pin in the designated groove in the
rammer.
You have now assembled your Ego7.
 
 
 

NOTE: CHECK THAT NO WIRES ARE TRAPPED BEFORE TIGHTENING
DOWN THE FRAME SCREWS
NOTE: TWIST THE BBSS WIRES SO THAT THEY DO NOT OBSTRUCT
THE MOVEMENT OF THE MICROSWITCH LEVER.












