User's Manual

(CONTINUED)
Remove the entire LPR assembly, the valve spring and the
exhaust valve from the marker body (SEE FIGURE 13.7). Using a
1/8th” hex key remove the valve plug from the underside of
the Ego7 body (SEE FIGURE 13.8). A solid brass or Delrin surface
should now be visible - this is the bottom of the exhaust
valve guide (SEE FIGURE 13.9). Ensure that the rammer is in its
rear position and taking an L-shaped hex key, place it down
through the bolt slot in the top of the body so that you can
apply light pressure to pop the valve guide out of its place in
the Ego7 body (SEE FIGURE 13.10).
Note how one side of the exhaust valve guide is at
(SEE FIGURE 13.11), whilst the other is raised to create the surface
that the exhaust valve seals on (SEE FIGURE 13.12). Inspect the
sealing face of both the exhaust valve guide and the exhaust
valve for any excessive wear or damage. If the exhaust valve
or the exhaust valve guide is damaged then replace using
authentic Ego7 parts.
You have now stripped the Ego7.
 

 












