User's Manual

THE SETUP MENU
To activate the SET-UP Menu, rst remove the three rubber
grip screws from the right hand side of the frame
(SEE FIGURE 8.1) and peel back the rubber grip to expose the
PCB inside the frame. Press and hold the SET-UP button,
which is located on the PCB above the battery (SEE FIGURE8.2).
After one second, the LOCK parameter will be displayed
- this is the rst item on the SET-UP Menu as shown below:
Press the button to scroll down through each of the
items on the menu. Once the last item has been displayed,
pressing the button will cause the rst item to be
displayed.
Press the button to scroll up through each of the items on
the menu. Once the rst item has been displayed, pressing
the button will cause the last item to be displayed.
Press the button to select the displayed item.
Selecting EXIT will return the display to the display from
which the SET-UP Menu was selected.


