User's Manual

ADJUSTING
YOUR VELOCITY
When using your Eclipse Ego7, you may wish to change the
velocity at which your Eclipse Ego7 is ring. This is done
by inserting a 1/8th" hex key into the adjuster screw at the
bottom of your Eclipse Ego7 Inline regulator and adjusting
it accordingly (SEE FIGURE 6.1). By turning this adjuster screw
clockwise you decrease the output pressure of the inline
regulator and consequently the velocity, by turning the
adjuster screw counter clockwise you increase the output
pressure of the inline regulator and consequently the velocity.
ADJUSTING
YOUR LPR PRESSURE
When using your Eclipse Ego7, you may wish to change the
output pressure of your LPR. This is easily done by inserting
a 5/32nd" inch hex key into the adjuster screw at the front
and adjusting it accordingly (SEE FIGURE 6.2).
By turning the adjuster screw clockwise, you decrease the
output pressure of your LPR and consequently reduce the
pressure driving your rammer back and forth. By turning
the adjuster screw counter clockwise, you increase the
output pressure of your LPR and consequently increase the
pressure driving your rammer back and forth.
NOTE: AFTER EACH ADJUSTMENT FIRE TWO CLEARING
SHOTS TO GAIN AN ACCURATE VELOCITY READING.
NEVER EXCEED 300FPS.
NOTE: TURNING THE ADJUSTER SCREW OUT TOO FAR
WILL CAUSE IT TO FALL OUT.


