User's Manual

USING THE BREAK
BEAM SENSOR SYSTEM
The Break Beam Sensor System is used to detect when a
paintball is ready to re from the Ego7. If no paintball is ready
then the BBSS will inhibit the Ego7 from ring. This prevents
the Ego7 from ‘Chopping’ paintballs that are not fully loaded
into the marker.
To switch off the Break-Beam Sensor System, press and
hold the button for one second (SEE FIGURE 3.2).
The eye on icon in the top left hand corner of the LCD
screen will change to the eye off icon indicating that the
Break-Beam Sensor System has been disabled.
To switch the Break-Beam Sensor System back on, press
and hold the button for one second. The eye off icon in
the top left hand corner of the LCD screen will change to the
eye on icon indicating that the breech sensor has been
enabled.
When the Break-Beam Sensor System is enabled, the icon
will change depending on if the system has detected a ball
or not. When no ball has been detected the icon looks like
this when a ball has been detected the icon changes to
look like this .
Additional features of the egos Break-Beam Sensor System
are covered in full in the "Using Your Ego7" section of this
user manual.
NOTE: WHEN TURNING ON THE ECLIPSE EGO7, THE BREAK-
BEAM SENSOR SYSTEM IS AUTOMATICALLY ENABLED













