Manual
INSTALLING
A 9V BATTERY
Ensure that the Eclipse Ego7 is switched off. Lay the marker
VUHÅH[Z\YMHJLPUMYVU[VM`V\^P[O[OLMLLK[\ILM\Y[OLZ[
away and with the barrel pointing to the right.
Use a 5/64” hex wrench to remove the three countersunk
screws that hold the rubber grip onto the frame (Note: a
2mm hex key can also be used). Peel the grip to the right to
expose the electronics within the frame.
If present, remove the existing battery by sliding your thumb
VYÄUNLYPU[V[OLYLJLZZILSV^[OLIH[[LY`HUKSL]LYPUN[OL
battery out of the frame (SEE FIGURE 2.1).
Do Not pull on the top of the battery to remove it as this can
cause the battery terminals to bend and will result in a poor
electrical connection.
Fit a 9-volt alkaline battery (type PP3, 6LR61 or MN1604)
into the recess with the battery terminals away from you. The
positive terminal should be on the right hand side, nearest to
the side of the frame (SEE FIGURE 2.2).
Ensure that all of the wires are within the recess of the
frame then replace the rubber grip and replace the three
countersunk screws.
Do Not over-tighten the screws.
NOTE: BATTERY VOLTAGE MUST NOT EXCEED 10 VOLTS.
SOME 9 VOLT RECHARGEABLE BATTERIES CAN EXCEED
THIS VOLTAGE IF OVER CHARGED. IF IN DOUBT DO NOT
USE RECHARGEABLE BATTERIES.
=@>)%)
=@>)%(
0%FI@<EK8K@FE
:FEK<EKJ
FI@<EK8K@FE
HL@:B$J<KLG
LJ@E>PFLI<>F.
8;M8E:<;J<KLG
;@JGC8PD<ELKI<<
D8@EK<E8E:<
=8LCK=@E;@E>
J<IM@:<:<EKI<J
G8IKJC@JK
JG8I<J8::<JJFI@<J
HL@:B>L@;<