Manual

SYMPTOM POSSIBLE CAUSE
My Trigger is very “Bouncy”, how can I
reduce it?
The Break-Beam Sensor System does not
appear to be reading correctly.
The Break-Beam Sensor System is not reading
at all.
Tw o o r mo r e b al l s a re b e i n g fe d i n t o t he b r e ec h .
Incorrect Filter settings.
Lengthen and strengthen your trigger pull.
The Break-Beam Sensor System is dirty.
Break-Beam Sensors are the wrong way
around.
There is a broken wire or contact, or a short
circuit on either of the Breech Sensor cables.
Either sensor is back to front.
If the Eclipse Ego7 is being used with a force
feed loader, it is possible that the loader is
forcing balls past the ball detent.
Check that your trigger pull is within the limits of
your BAND HI and BAND LO settings and that
your TT TOL suits your current set-up.
Refer to Advanced Set-Up Section for
guidelines of how to adjust your Ego7 Trigger
accordingly.
Keep the Break-Beam Sensors clean to ensure
correct readings
(SEE MAINTENANCE SECTION)
.
Check that the red receiver is on the right-hand
side of the Breech.
Check the plug of the cables.
Check for cuts or pinches in the sensor cables.
Check that the sensors face each other when
installed.
*OHUNL[OLY\IILYÄUNLYKL[LU[
SOLUTION
-.%=8LCK=@E;@E>
:FEK<EKJ
FI@<EK8K@FE
HL@:B$J<KLG
LJ@E>PFLI<>F.
8;M8E:<;J<KLG
;@JGC8PD<ELKI<<
D8@EK<E8E:<
=8LCK=@E;@E>
J<IM@:<:<EKI<J
G8IKJC@JK
JG8I<J8::<JJFI@<J
HL@:B>L@;<