Manual
(CONTINUED)
Gently move the trigger forward and carefully remove it
from the trigger frame taking care not to damage the micro
switch or the optical sensors (SEE FIGURE 15.6). Clean the trigger
thoroughly and also clean the space within the frame that
the trigger sits in (SEE FIGURE 15.7).
Replace the trigger into the frame making sure that it is
sitting in the correct position so that the bottom prong
passes cleanly through the optical sensor and the set screw
moves towards the micro switch. Replace the bearing carrier
and using the 5/32” hex key tighten the two bearing carrier
retaining screws down into the frame (SEE FIGURE 15.8). Having
lined up the trigger with the bearing carrier and the frame,
replace the trigger pin to hold the trigger securely in place
in the frame (SEE FIGURE 15.9). Using a 1/16” hex key tighten the
trigger pin retaining set screw at the rear of the trigger to
OVSK[OL[YPNNLYWPUÄYTS`PUWSHJLPU[OLMYHTL(SEE FIGURE 15.10).
You have now stripped and cleaned your Ego7 trigger.
=@>(,%. =@>(,%/
=@>(,%-
=@>(,%0 =@>(,%('
-(%D8@EK<E8E:<
:FEK<EKJ
FI@<EK8K@FE
HL@:B$J<KLG
LJ@E>PFLI<>F.
8;M8E:<;J<KLG
;@JGC8PD<ELKI<<
D8@EK<E8E:<
=8LCK=@E;@E>
J<IM@:<:<EKI<J
G8IKJC@JK
JG8I<J8::<JJFI@<J
HL@:B>L@;<