Manual

HOW TO
ASSEMBLE THE EGO7
Having stripped down the Ego7, here is a guide on how we
recommend you re-assemble it.
Lubricate both of the O-rings on the exhaust valve guide
with Eclipse Oil (SEE FIGURE 14.1). Place the exhaust valve in the
exhaust valve guide, making sure that the sealing faces are
next to each other, and place the valve spring over the end
of the exhaust valve (SEE FIGURE 14.2). Holding the exhaust valve
guide so that the closed side of it is facing the bottom of the
marker body, insert the exhaust valve guide, exhaust valve
and valve spring into the front of the marker body
(SEE FIGURE 14.3). When the exhaust valve is in the correct place,
you will be able to see the closed side through the valve
plug hole in the Ego7 body (SEE FIGURE 14.4). Make sure that the
exhaust valve guide is lined up correctly and then take a
1/8th” hex key and replace the valve plug (SEE FIGURE 14.5).
Lubricate both of the O-rings on the LPR body with Eclipse
Oil (SEE FIGURE 14.6) and slide the LPR assembly into the front of
the Ego7 marker body until the hole in the LPR body lines up
with the hole in the front regulator mount (SEE FIGURE 14.7).
WARNING: DE-GAS YOUR MARKER, DISCHARGING
ANY STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER AND AIR SYSTEM TO MAKE THE
MARKER EASIER TO WORK ON.
WARNING
=@>(+%) =@>(+%*
=@>(+%+ =@>(+%,
=@>(+%- =@>(+%.
=@>(+%(
NOTE: DO NOT OVER TIGHTEN THE VALVE PLUG SCREW!
,/%D8@EK<E8E:<