Manual
HOW TO
STRIP THE EGO7...
Note: The number of QEVs and the appearance of the
LPR body may vary according to the model of Ego7 that
you have.
Lift the bolt pin and slide the bolt out of the rear of the
marker. Disconnect any hosing and unscrew the inline
regulator from the front regulator mount as detailed in the
“Cleaning the Inline Regulator” section of this Maintenance
guide.
Using a 5/64th” hex key remove the six screws that attach
the Ego7 rubber grips to the Ego7 grip frame (SEE FIGURE 13.1).
Unplug the solenoid and unplug the break beam sensor
system from their connections on the Ego7 circuit board
(SEE FIGURE 13.2).
Using a 1/8th” hex key undo the two frame retaining screws
(SEE FIGURE 13.3) and remove the frame from the Ego7 body,
taking care not to damage any wires (SEE FIGURE 13.4). Take the
Ego7 body and turn it so that the underside of the solenoid,
QEV and Valve plug are all be visible and accessible
(SEE FIGURE 13.5). Using a 1/8th” hex key remove the screw from
the front regulator mount that holds the LPR Body into the
marker body (SEE FIGURE 13.6).
WARNING: DE-GAS YOUR MARKER, DISCHARGING
ANY STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER AND AIR SYSTEM TO MAKE THE
MARKER EASIER TO WORK ON.
WARNING
=@>(*%+
=@>(*%* =@>(*%+
=@>(*%)
=@>(*%, =@>(*%-
=@>(*%(
,-%D8@EK<E8E:<