Manual
CLEANING THE LPR
The Inline regulator can be removed if needs be.
Unscrew the low-pressure regulator cap from the marker
body (SEE FIGURE 11.1).
Remove the LPR piston and rear spring from the LPR cap
(SEE FIGURE 11.2).
Cupping the palm of one hand, turn the LPR cap upside
down and tip the front spring out into your palm (SEE FIGURE 11.3).
Remove the rear spring from the LPR piston and using a dry
Q-tip, carefully clean the seal on the LPR piston (SEE FIGURE 11.4).
If the seal is damaged, replace as necessary. Once the seal
has been cleaned, lubricate with a light application of Eclipse
Paintball Gun Oil so that it is ready for re-assembly.
WARNING: DE-GAS YOUR MARKER, DISCHARGING
ANY STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER AND AIR SYSTEM TO MAKE THE
MARKER EASIER TO WORK ON.
WARNING
NOTE: THE ADJUSTER PISTON (COLOURED CAP THAT
THE FRONT SPRING RESTS IN) DOES NOT NEED TO
BE REMOVED FROM THE LPR CAP FOR REGULAR
MAINTENANCE.
=@>((%)
=@>((%+=@>((%*
=@>((%(
,)%D8@EK<E8E:<