Manual

5. Set the FRONT STOP TRIGGER SCREW as required,
ensuring that the bar is as close to 0% as possible when the
trigger is fully released against the set screw. It is advisable
to allow for some extra travel in the trigger release once the
bar has reached its minimum value.
6. Adjust the BAND LO parameter so that when the trigger
is fully released the bar settles beneath the indicator on the
left hand side of the screen (SEE PAGE 43).
7. Set the MAGNET RETURN STRENGTH SCREW and
the Micro Switch Activation Screw as required, making both
the spring tension and the return force as strong as possible
without compromising the “feel” of the trigger.
Optional (only if TT had been selected in Debounce
parameter):
8. Select the TT TOL parameter.
With the gun gassed up and
WYLMLYHIS`Ä[[LK^P[OSVHKLYHUK
ÄYPUNWHPU[[Y`[VNL[[OLTHYRLY[V
bounce by pulling the trigger very
slowly. If the marker bounces, then
reduce the TT TOL value until it no
longer does so. If the marker does
not bounce then increase the TT
TOL value until it starts to bounce
and then reduce it again until the
bouncing stops.
Whilst this set up process should
completely eliminate bounce, it may
result in a trigger pull that is not
ideally suited to the user, in which
case it will be necessary to make
adjustments to the trigger and then
modify the ID FILTER parameters
accordingly.
TRAINING
The TRAINING Menu allows the user to enable or disable
training mode; this is where the marker cycles but does not
ÄYL
The TRAINING Menu looks like this:
If TRAINING is switched On”, then the marker will cycle
^P[OV\[VWLUPUN[OL]HS]LHUK^PSSWYV]PKLHUHPYLMÄJPLU[
means of testing your latest selection of setting without
creating any unnecessary noise. If TRAINING is switched
Off then the marker will perform as normal.
To a lte r the TRAINING setting, scroll through the SET-UP
Menu until TRAINING is displayed. The current state of
the TRAINING will be displayed on the right hand side of the
screen. To alter the state of the TRAINING, press
the button to enter the parameter and the edit indicators
will appear.
NOTE: THE FASTEST WAY TO SHOOT AN EGO7 IS TO
WALK THE TRIGGER WITH TWO OR MORE FINGERS.
FEATHERING (NOT FULLY RELEASING) THE TRIGGER WILL
CAUSE THE FILTERING SYSTEM TO REDUCE THE RATE OF
FIRE DOWN IN ORDER TO ELIMINATE WHAT IT PERCEIVES
AS TRIGGER BOUNCE.
++%8;M8E:<;J<K$LG