Manual
SETTING
THE TRIGGER CONT...
Turn the screw counter clockwise to reduce the amount
of force. Do not turn the screw too far or there will not be
enough force to return the trigger (SEE FIGURE 7.3).
The Micro Switch Activation Screw is used to adjust the
point at which in the trigger pull the micro switch is activated.
Turn the screw clockwise to decrease the amount of
trigger travel to the activation point. Turn the screw counter
clockwise to increase the amount of trigger travel to the
activation point (SEE FIGURE 7.4).
If you have selected MSWICTH from the HARDWARE
Menu and are consequently using the Micro Switch as
the method of trigger detection then check that the Micro
Switch activates and de-activates fully on each trigger pull
and trigger release. If you have selected OPTO from the
HARDWARE Menu and are using the OPTO Sensor as the
method of trigger detection, refer to setting the BAND HI
and BAND LO (SEE PAGE 42-43) as it is crucial that the trigger pull
HUK[YPNNLYÄS[LYZHYLZL[\W[VNL[OLYMVY[OL[YPNNLYÄS[LYPUN[V
work correctly.
=@>.%*
=@>.%+
).%LJ@E>PFLI<>F.
:FEK<EKJ
FI@<EK8K@FE
HL@:B$J<KLG
LJ@E>PFLI<>F.
8;M8E:<;J<KLG
;@JGC8PD<ELKI<<
D8@EK<E8E:<
=8LCK=@E;@E>
J<IM@:<:<EKI<J
G8IKJC@JK
JG8I<J8::<JJFI@<J
HL@:B>L@;<