Manual
INSTALLING AN
ADJUSTABLE AIR SYSTEM
Firstly disconnect the ¼” hosing from the elbow attached to
the Eclipse OOPS at the base of the grip frame
(SEE FIGURE 4.4).
Unscrew the On/Off knob completely from the Eclipse
OOPS and using a 3/32nd hex key turn the two screws on
the left hand side of the integrated slide rail at the base of
the grip frame in a counter clockwise direction so that the
Eclipse OOPS can be removed from the rail by sliding it
backwards (SEE FIGURE 4.5).
As well as the integrated slide rail at the base of the Eclipse
Ego7’s grip frame, there are also two 10-32 UNF threaded
screw holes which will accept all standard bottom line
screws (SEE FIGURE 4.6).
Attach the air system of your choice, taking care to ensure
that you use the correct length and size of hosing to
accommodate your requirements.
BEFORE ATTACHING ANY FIXED AIR SYSTEM, PLACE
ATTACHING SCREW IN DESIGNATED SLIDE RAIL AND
MEASURE PROTRUDING SCREW LENGTH. SCREW
LENGTH MUST NOT PROTRUDE MORE THAN 10MM/0.40”
OTHERWISE THE EGO7 PRINTED CIRCUIT BOARD WILL
BECOME DAMAGED.
WARNING
=@>+%-
=@>+%,
=@>+%+
(+%LJ@E>PFLI<>F.