Manual

ATTACHING A LOADER
FIG 3.7
Using a 5/32” hex key, turn the top screw of the clamping feed tube counter
clockwise until the feed neck of your loader can easily be pushed into the top
of the clamping feed tube (SEE FIGURE 3.7). Push your choice of loader rmly into
the clamping feed tube so that it rests on the shelf inside the clamping feed tube
(SEE FIGURE 3.8). Using a 5/32” hex key, tighten the top screw of the clamping
feed tube by turning it clockwise until the loader is rmly gripped (SEE FIGURE 3.9).
You have now attached a loader to your Eclipse Ego. Once you have lled
your loader and air tank you will then be ready to begin using your Eclipse
Ego.
FIG 3.8
FIG 3.9
SWITCHING ON
Pressing and holding the button will switch the Eclipse Ego on. The LCD
display will show the Eclipse Ego logo. When the button is released, the
LCD display will show the selected display.
SCREEN LAYOUT
The standard layout of an Eclipse Ego display is as follows:
Firing Mode
Data
Battery Level Indicator
Break-Beam Sensor System Indicator
16
USING YOUR EGO
17
USING YOUR EGO
QUICKGUIDE