Manual
FIG 3.2
SETTING UP
Before you can begin to use your Eclipse Ego, there are a few necessary
components that are required to enable the Eclipse Ego to function; namely
an air system and a loader of your choice.
NOTE: THE ECLIPSE EGO CANNOT BE USED WITH Co2, IT CAN ONLY
BE POWERED BY COMPRESSED AIR OR NITROGEN.
INSTALLING A
PRESET AIR SYSTEM
Every Eclipse Ego comes complete with an Eclipse On/Off System allowing a
preset regulator and tank to be screwed straight in for immediate use. Before
screwing the preset into the Eclipse On/Off ensure that the On/Off knob is
wound out approximately half way [SEE FIGURE 3.1].
Be careful not to unscrew the On/Off knob too far as it will come completely
out of the Eclipse On/Off System. If this happens, replace
the On/Off knob by screwing it back into the Eclipse
On/Off system in a clockwise direction.
Screw the preset air system into the
Eclipse On/Off System [SEE FIGURE 3.2]
so that the bottle screws in all the
way and is tight. Slowly turn the
On/Off knob in a clockwise direction
allowing the Eclipse On/Off System
to depress the pin of the preset air
system causing the Eclipse Ego to
become pressurized, providing that
there is sufcient air in your tank [SEE
FIGURE 3.3].
You have now installed a preset air
system onto your Eclipse Ego.
NOTE: WHEN USING AN ECLIPSE ON/OFF ON YOUR ECLIPSE
EGO, THE ECLIPSE EGO WILL STILL HAVE STORED AIR IN THE
VALVE CHAMBER, GAS LINE AND INLINE REGULATOR AFTER YOU
HAVE SWITCHED THE ECLIPSE ON/OFF OFF. PLEASE REMEMBER
TO DISCHARGE THE STORED AIR IN A SAFE DIRECTION AS YOU
ARE UNSCREWING THE ON/OFF KNOB ON THE ECLIPSE ON/OFF
SYSTEM.
INSTALLING AN
ADJUSTABLE AIR SYSTEM
Firstly disconnect the ” hosing from the elbow attached to the Eclipse On/
Off system at the base of the grip frame [SEE FIGURE 3.4].
Unscrew the On/Off knob completely from the Eclipse On/Off system and
using a 3/32nd hex key turn the two screws on the left hand side of the
integrated slide rail at the base of the grip frame in a counter clockwise
direction so that the Eclipse On/Off can be removed from the rail by sliding it
backwards [SEE FIGURE 3.5].
As well as the integrated slide rail at the base of the Eclipse Egos grip frame,
there are also two 10-32 UNF threaded screw holes which will accept all
standard bottom line screws [SEE FIGURE 3.6].
Attach the air system of your choice, taking care to ensure that you use the
correct length and size of hosing to accommodate your requirements.
FIG 3.5
FIG 3.3
FIG 3.1
FIG 3.4
FIG 3.6
WARNING: BEFORE ATTACHING ANY FIXED AIR SYSTEM,
PLACE ATTACHING SCREW IN DESIGNATED SLIDE RAIL AND
MEASURE PROTRUDING SCREW LENGTH. SCREW LENGTH
MUST NOT PROTRUDE MORE THAN 10MM/0.40” OTHERWISE
THE EGO PRINTED CIRCUIT BOARD WILL BECOME DAMAGED.
14
USING YOUR EGO
15
USING YOUR EGO
QUICKGUIDE