Manual

THE EGO

NAVIGATION CONSOLE

At the rear of the Ego’s grip frame you will nd the Navigation Console. The

Navigation Console is used for several purposes including:

- TURNING THE EGO ON AND OFF USING THE BUTTON

- SCROLLING THROUGH MENU CHOICES WITH AND BUTTONS

- SELECTING PARAMETERS TO EDIT USING THE BUTTON

- EDITING PARAMETERS USING THE AND BUTTONS

- TURNING THE EGO BBSS ON AND OFF USING THE BUTTON

- RESETTING CERTAIN DISPLAY FEATURES USING THE BUTTON

SELECT

FWD / RAISE

BACK / LOWER

INSTALLING A BATTERY

Ensure that the Eclipse Ego is switched off. Lay the marker on a at surface

in front of you, with the feed tube furthest away and with the barrel pointing

to the right.

Use a 5/64” hex wrench to remove the three countersunk screws that hold the

rubber grip onto the frame (Note: a 2mm hex key can also be used). Peel the

grip to the right to expose the electronics within the frame.

If present, remove the existing battery by sliding your thumb into the recess

below the battery and levering the battery out of the frame (SEE FIGURE 2.1).

DO NOT pull on the top of the battery to remove it as this can cause the battery

terminals to bend and will result in a poor electrical connection.

Fit a 9-volt alkaline battery (type PP3, 6LR61 or MN1604) into the recess with

the battery terminals away from you. The positive terminal should be on the

right hand side, nearest to the side of the frame (SEE FIGURE 2.2).

Ensure that all of the wires are within the recess of the frame then replace the

rubber grip and replace the three countersunk screws.

DO NOT OVER-TIGHTEN THE SCREWS.

FIG 2.1

FIG 2.2

ORIENTATION

QUICK SET-UP

QUICKGUIDE