Manual
SYMPTOM POSSIBLE CAUSE SOLUTION
Although a fresh battery has been tted, the
Eclipse Ego will not switch on.
The Battery does not seem to last very long.
The Eclipse Ego leaks from the Solenoid
The Battery has been tted incorrectly.
The Battery terminals are not making proper
contact with the battery.
The Battery type is of a low quality.
Check that 3 solenoid seals are intact and
seated correctly in their designated pockets in
the Minifold.
Dirt on Spool of Ego Solenoid.
Damaged Eclipse Ego Solenoid.
LPR is supercharging causing intermittent
leaking.
Check for damaged or incorrect seals on
Rammer.
Is it leaking from the Barbs?
Fit the Batery correctly with the positive
terminal nearest to the side of the frame.
Remove the Battery, gently bend the terminals
towards where the Battery will sit and then
replace the Battery.
Use an alkaline or metal hydride battery. Do
not use a low quality or rechargeable battery.
Replace seals if damaged using Eclipse Ego
Parts kit. Ensure seals are sealed correctly.
Strip and clean Solenoid ( See Maintenance
Section ).
Replace Eclipse Ego Solenoid.
Clean LPR Piston seal.
Inspect regulator seal (in LPR Piston) and
regulator seat (in LPR Body). Replace if
neccessary.
Replace seals.
Check hose for cuts or replace barbs.
SYMPTOM POSSIBLE CAUSE SOLUTION
The Eclipse Ego leaks down barrel
Gas vents quickly down barrel as soon as it is
gassed up.
The marker is chopping or trapping paint.
The Eclipse Ego res yet bolt doesn’t move.
Leaky Exhaust Valve.
Damaged Valve Seat.
Incorrect seal on front of Rammer Housing.
The Exhaust Valve has become jammed in the
brass valve guide.
The Break-Beam Sensor System is switched
off.
The Bolt is dirty, causing the sensor system to
incorrectly detect a retracted bolt.
The Break-Beam Sensor System is dirty
causing the incorrect detection of paintballs.
Bolt pin is not located in Rammer correctly.
Replace Exhaust Valve.
Replace Rammer Housing.
Replace front seals on Rammer Housing with
016 seals.
Replace Exhaust Valve and brass valve guide
as necessary ( see Maintenance Section ).
Switch on the Break-Beam Sensor System.
Increase the breech open time.
Clean the Bolt.
Clean the Break-Beam Sensor System.
Lift Bolt pin and line up with position of
rammer correctly ( See Maintenance Section ).
58
FAULT FINDING
59
FAULT FINDING
QUICKGUIDE