Manual

FIG 6.35

FIG 6.36

FIG 6.33

FIG 6.32

FIG 6.30

CLEANING AND

LUBRICATING THE RAMMER

FIG 6.34

FIG 6.28

Pull the bolt pin upwards so that it dis-engages the rammer, allowing the bolt

to be removed via the rear of the Eclipse Ego (SEE FIGURE 6.28).

Using a 3/16" hex key, unscrew and remove the rammer cap at the rear of the

Eclipse Ego (SEE FIGURE 6.29).

Raise the front of the Eclipse Ego and tap the Eclipse Ego onto your hand until

the rammer falls into the palm of your hand (SEE FIGURE 6.30).

Thoroughly clean the rammer shaft and all of its seals, paying special attention

to the seal on the middle of the shaft (SEE FIGURE 6.31), the rear seal (SEE FIGURE

6.32) and the condition of the bumper at the rear of the shaft

(SEE FIGURE 6.33).

Replace any worn seals/bumpers using authentic

Eclipse Ego spare parts.

FIG 6.29

Lubricate all of the seals on the rammer shaft and replace the rammer into the

rear of the Eclipse Ego body with the bumper at the back (SEE FIGURE 6.34).

Note: Use light paintgun oil.

Replace the rammer cap, using the 3/16" hex key to secure it into the Eclipse

Ego body (SEE FIGURE 6.35).

Noting the position of the rammer in the Eclipse Ego body (SEE FIGURE 6.36),

replace the bolt and locate the bolt pin into the designated groove in the

rammer shaft (SEE FIGURE 6.37).

FIG 6.31

WARNING: DE-GAS YOUR MARKER, DISCHARGING ANY STORED

GAS IN A SAFE DIRECTION, AND REMOVE THE BARREL AND

LOADER TO MAKE THE EGO EASIER TO WORK ON.

FIG 6.37

Continued >

MAINTENANCE

QUICKGUIDE