Manual

ManualsBrandsPlanet Eclipse ManualsPaintballEgo 06 Marker

FIG 4.5

FIG 4.2

SETTING THE TRIGGER

There are four adjustment points on the trigger – the FRONT STOP TRIGGER

SCREW, the REAR STOP TRIGGER SCREW, the MAGNET RETURN STRENGTH SCREW and

the SPRING TENSION SCREW.

As standard each Eclipse Ego comes with a factory set trigger travel of

approximately 2mm in total length; one millimeter of travel before the

ring point and one millimeter of travel after the ring point.

The FRONT STOP TRIGGER SCREW is used to set the amount of trigger

travel prior to the marker ring. Turn this screw clockwise to reduce

the amount of travel. Do not turn the screw too far or the trigger will

be pushed past the ring point and the marker will not work. Turn this

screw counter clockwise to increase the amount of trigger travel [SEE

FIGURE 4.1].

The REAR STOP TRIGGER SCREW is used to set the amount of travel after the

marker has red. Turn this screw clockwise to reduce the amount of travel.

Do not turn the screw too far or the trigger will be prevented from reaching its

ring point and the marker will not work. Turn this screw counter clockwise to

increase the amount of travel [SEE FIGURE 4.2].

The MAGNET RETURN STRENGTH SCREW is used to adjust the amount of force

with which the trigger is returned to its rest position by the magnet. Turn the

screw clockwise to increase the amount of force. Do not turn the screw too

far or it will negate the position of the Front Stop Trigger Screw. Turn the screw

counter clockwise to reduce the amount of force. Do not turn the screw too far

or there will not be enough force to return the trigger [SEE FIGURE 4.3].

The SPRING TENSION SCREW is used to adjust the amount of spring tension

behind the trigger when it is pulled. Turn the screw clockwise to increase the

amount of spring tension. Turn the screw counter clockwise to reduce the

amount of spring tension [See FIGURE 4.4].

Once you have set the trigger to your preference, refer to setting the BAND HI

and BAND LO (SEE PAGE 37), as it is very important that the BAND HI, BAND LO and

trigger pull are set up together for the trigger ltering to work correctly.

FIG 4.1

THE SET UP MENU

To activate the SET-UP Menu, rst remove the three rubber grip screws from

the right hand side of the frame (SEE FIGURE 4.4) and peel back the rubber grip

to expose the PCB inside the frame. Press and hold the SET-UP button, which

is located on the PCB above the battery (SEE FIGURE 4.5). After one second,

the MODE parameter will be displayed - this is the rst item on the SET-UP Menu

as illustrated below:

FIG 4.4

FIG 4.3

FIG 4.4

SELECT

FWD / RAISE

BACK / LOWER

Press the button to scroll down through each of the items on the menu.

Once the last item has been displayed, pressing the button will cause the

rst item to be displayed.

Press the button to scroll up through each of the items on the

menu. Once the rst item has been displayed, pressing the button will

cause the last item to be displayed.

Press the button to select the displayed item.

Selecting

BACK

will return the display to the display from which the

SET-UP

Menu was selected.

ADVANCED SET-UP

QUICKGUIDE