Manual

FIG 3.11
FIG 3.10
UNDERSTANDING
THE BBSS OPERATION
The BBSS is able to switch itself off in the event that a blockage or
contamination prevents it from functioning correctly. In this instance, the
BBSS will switch itself back on once the blockage is cleared and the correct
operation can be resumed.
The BBSS icon on the main screen is used to indicate the six possible states
of the BBSS as follows:
The BBSS is enabled and a ball is detected. The Ego can be
red at the maximum rate of re determined by the chosen
ring mode.
The BBSS is enabled and no ball is detected. The Ego cannot
be red.
The BBSS is disabled. The Ego can be red at a maximum
rate of re as set by the OFF ROF parameter ( see page 32 ).
A BBSS fault has been detected and the system is disabled.
The Ego can only be red at a maximum rate of re of 10bps,
regardless of the chosen ring mode.
ADJUSTING
YOUR VELOCITY
When using your Eclipse Ego, you may wish to change the velocity at which
your Eclipse Ego is ring. This is done by inserting a 1/8th" hex key into the
adjuster screw at the bottom of your Eclipse Ego Inline regulator and adjusting
it accordingly (SEE FIGURE 3.10). By turning this adjuster screw clockwise you
decrease the output pressure of the inline regulator and consequently the
velocity, by turning the adjuster screw counter clockwise you increase
the output pressure of the inline regulator and consequently the velocity.
NOTE: AFTER EACH ADJUSTMENT FIRE TWO CLEARING SHOTS TO
GAIN AN ACCURATE VELOCITY READING. NEVER EXCEED 300FPS.
ADJUSTING
YOUR LPR PRESSURE
When using your Eclipse Ego, you may wish to change the output pressure
of your LPR. This is easily done by inserting a 5/32nd" inch hex key into the
adjuster screw at the front and adjusting it accordingly (SEE FIGURE 3.11).
By turning the adjuster screw clockwise, you decrease the output pressure
of your LPR and consequently reduce the pressure driving your rammer back
and forth. By turning the adjuster screw counter clockwise, you increase the
output pressure of your LPR and consequently increase the pressure driving
your rammer back and forth.
NOTE: TURNING THE ADJUSTER SCREW OUT TOO FAR WILL CAUSE
IT TO FALL OUT.
A BBSS sensor fault has been cleared and the sensor has
been re-enabled. A ball is detected and the Ego can be red
at the maximum rate of re determined by the chosen ring
mode.
A BBSS fault has been cleared and the sensor is enabled.
No ball is detected so the Ego cannot be red. To reset the
BBSS icon, use the button to switch off the BBSS and
then back on again.
24
USING YOUR EGO
25
USING YOUR EGO
QUICKGUIDE