User's Manual

MaintenanceMaintenance

Maintenance

Cleaning and Lubricating

the Rammer

Pull the bolt pin upwards so that it dis-engages the

rammer, allowing the bolt to be removed via the rear of

the Eclipse Ego

(See Figure 6.28)

Using a 5/32nd" hex key, unscrew and remove the

rammer cap at the rear of the Eclipse Ego

(See Figure 6.29)

Raise the front of the Eclipse Ego and tap the Eclipse

Ego onto your hand until the rammer falls into the palm

of your hand

(See Figure 6.30)

Thoroughly clean the rammer shaft and all of its seals,

paying special attention to the seal on the middle of the

shaft

(See Figure 6.31)

, the rear seal

(See Figure 6.32)

and

the condition of the bumper at the rear of the shaft

(See Figure 6.33)

. Replace any worn seals/bumpers

using authentic Eclipse Ego spare parts.

WARNING

De-gas your marker,

discharging any stored gas in a safe direction,

and remove the barrel and loader to make the

Ego easier to work on.

FIGURE 6.28

FIGURE 6.29

FIGURE 6.30

Maintenance