Manual
07
FIG-1
A
Ensure that the marker is switched OFF before you begin.
B
Connect both parts of the barrel together.
Rotate the barrel tip counter-clockwise onto the barrel insert.
C
Attach the complete barrel to the marker.
Rotate the barrel clockwise into the marker body.
D
Fit a barrel blocking device for safety.
E
Ensure the marker is de-gassed.
Push in and hold the POPS button and pull the POPS bonnet away
from the POPS body.
F
Attach a pre-set air system.
Rotate the air system clockwise into the POPS body.
G
Loosen the clamping feed-neck.
Open the feed-neck lever away from the feed-neck.
Rotate the feed-neck lever screw counter-clockwise.
H
Attach a loader.
If the feed-neck is too tight, loosen the clamping feed-neck more.
I
Secure the loader.
Rotate the feed-neck lever screw clockwise to tighten.
Close the feed-neck lever to secure.
J
Gas the marker.
Push the POPS bonnet into the POPS body until it engages.
K
Switch ON the CS2.
1
IMPORTANT! To switch OFF/ON, see page 08.
2
DO NOT over-tighten the barrel.
3
IMPORTANT! Ensure that the marker is de-gassed when setting up.
4
NEVER use CO2. Compressed air or nitrogen only.
5
DO NOT use a preset regulator that outputs over 650 psi.
6
DO NOT over-tighten the feed-neck. This may damage the CS2 or
the loader.
INTRODUCTION
SETTING UP THE CS2
WARNING!
Always make sure the marker is O with a barrel blocking device installed and
that no paintballs are in the CS2 or loader before installing an air system.
Compressed air and nitrogen systems can be extremely dangerous if handled
or used incorrectly.
Only attach an air system certied for use within the country of use.
Never add lubricants or grease into the ll adaptor of the air system regulator.
Ensure that all screws are tightened and no parts are loose before installing an
air system.
Do not pressurise the CS2 without the bolt system correctly installed, as high
pressure gas will be emitted.
Do not install a compressed air system or load paintballs into the CS2 until you
feel condent with your ability to handle the marker safely and responsibly.
WARNING