Manual

FIG-2

FIG-1

FIG-3

ELECTRONICS

USER INTERFACE PARAMETERS

FIG-1 - RAMP SET-UP MENU

This menu is only available when RAMP has been selected as the FIRE MODE parameter.

FIG-2 - TYPE PARAMETER

Select the type of ramping required:

> STEP:

The CS2 will re in semi-automatic until a number of trigger pulls (set by SEMI SHOTS)

have been made at a minimum pull rate (set by KICK IN). The CS2 will then re at up to the

maximum rate of re (set by BS ON ROF) as long as the trigger is continually pulled at a

required rate (set by SUSTAIN).

> LINEAR:

The CS2 will re in semi-automatic until a number of trigger pulls (set by SEMI SHOTS) have

been made at a minimum pull rate (set by KICK IN). The rate of re will then equal the rate

of trigger pulls increased by a percentage (specied by RATE) up to a maximum rate of re

(set by BS ON ROF). Ramping is maintained as long as the trigger is continually pulled at a

required rate (set by SUSTAIN).

FIG-3 - RATE PARAMETER

Only available when the RAMP TYPE parameter is set to LINEAR. This sets the percentage

increase in rate of re over rate of trigger pulls.

If the RATE is 50% and the trigger is pulled at 10 bps then the actual rate of re is 15 bps

(10 + 50%).

This parameter can be set between 0 and 100% in 10% increments.